zhangxiaosan
Legenda soseske
Pridružen/-a: 27.09. 2016, 06:54
Prispevkov: 1069
|
 Objavljeno: 25 Nov 2016 04:40 Naslov sporočila: Routine maintenance of paver |
 |
|
<p>Paver is also an indispensable part of road maintenance equipment, the daily maintenance and maintenance of the paver, most people may not be very familiar with the relative excavator,Gasoline saving cold recycling Maintenance Truck the paver is a relatively small minority of products, no Too many people to discuss its maintenance, the daily maintenance of the paver is to improve its service life and the use of an important condition for efficiency. Daily work and maintenance should refer to the requirements specified in the manual to carry out, there are special needs should be replaced.
There are the following main points.</p>
<p>First, check the oil and lubrication system, to see oil, fuel, coolant and hydraulic oil is sufficient, the quality is in line with the requirements, the parts without leakage,Top Rated pavement repair machine if necessary, should be added or replaced. Check that the central grease pump is working, that the grease is adequate and that its piping is clear. (No central grease pump models must be given every week to grease the whole point grease 3 times within 10 hours, before the sub-operation, in the future and filling; such as working hours beyond 10 hours to 4 ~ 5 Times, in the operation plus 1 or 2 times.)</p>
<p>Second, always clean the paver, check the electrical, gas and heating systems. Remove the asphalt, sticky sand, etc., to remove the engine, hydraulic components and other parts of the surface of old oil, dust, debris, dirt, etc .; check and clean the air filter; check all kinds of wearing parts and Easy to aging parts, need to be timely adjusted or replaced; the electrical system, fuses, lines and the electrical connector is intact,Fully Insulated Asphalt Tanks whether loose; each work before the work of the devices are no-load operation, check the normal operation of the working device ; At the same time check the heating system of the nozzle, connecting pipe, gas tank and the switch is normal.
Third, check the paver connection fastening. Including the connection is firm, intact, in particular, to ensure that the left and right track beam, screed, sub-device, and the scraper conveyor fastening. Check the tension and wear of the drive belt and chain.</p> |
|
